| ||||||||
|
 |
The Basswood Body is completely coated with sanding sealer
and smooth enough to paint with only minor finish sanding |
 |
| Figured Maple Veneer Bookmatched | Mahogony Veneer Back | |
 |  | |
| Front view of neck pocket | 5 Ply inside with 2 ply outside binding | |
 |
The neck fits inside the body and is bolted on from the
back |  |
| Bound 22 Fret Neck with Jumbo Frets | Bottom of neck heal | |
 |
Measures 1-11/16" at the nut and 2-3/16" at
the 22nd fret with a 12" Radius |  |
| Plastic slotted nut and truss rod
view | Ample
head stock measures 3-3/4" across at widest point and is 6-11/16" from
nut to tip | |
 |  | |
| Angled Headstock with Scarf Joint
located under frets 1 and 2 |
Potted and chrome covered humbucking pickups which are
color coded for wiring and measure out at approximately 8.0 ohm's each | |
 | 
| |
| Prewired control
cavity harness with 3 way switch and 500 ohm pots | Fully Adjustable chrome tune-o-matic
bridge SUNG IL BM002 with slotted saddles and polished chrome stop tailpiece | |
 |
Hardware packs |  |
| Strap Buttons with felt washers,
tuning machine washers and front nut attachments and screws | Knobs, nuts, switch ring, heat shrink
wrap and screws | |
 |  | |
| Truss rod, Pick Guard and shielded
electronics cover | Neck
Plate and mounting screws with truss rod allen wrench | |
 |  | |
| 18:1 High Quality sealed tuners | String Pack, cord and decal | |
 |
Complete instructions provided |
 |
| Directions for finishing | Directions for assembly | |
| Things you
will need | Things
you will need | |
| Small
saw for shaping the headstock, sandpaper, paint and buffing supplies | Philips Screw driver, 7/16"
wrench, lighter |
