| ||||||||
|
 |
The Body is completely coated with sanding sealer and smooth
enough to paint with only minor finish sanding |
 |
| Highly Figured Maple Veneer Bookmatched | Basswood Body usually 3 or 4 pieces | |
 |
The neck fits inside the body under the neck pickup and
is bolted on from the back of the body |  |
| Front view of neck pocket | 22 Fret Neck with Jumbo Frets | |
 |
Measures 1-11/16" at the nut and 2-1/4" at the
22nd fret |  |
| Bottom of neck heal | Plastic slotted nut and truss rod
view | |
 |
12" Radius |  |
| Ample head stock measures 3-3/4"
across at widest point and is 6-11/16" from nut to tip | Angled Headstock and Scarf Joint
located under frets 1 and 2 | |
 |
Easy to connect electronics |
 |
| Potted and chrome covered humbucking
pickups which are color coded for wiring and measure out at 8.0 ohm's each | Prewired control cavity harness with
3 way switch and 500 ohm pots | |
 |
Fully adjustable stop tailpiece |
 |
| Fully Adjustable chrome tune-o-matic
bridge SUNG IL BM002 with slotted saddles |
Drop forged and polished chrome stop tailpiece | |
 |
Hardware packs |  |
| Strap Buttons with felt washers,
tuning machine washers and front nut attachments and screws | Knobs, nuts, switch ring, heat shrink
wrap and screws | |
 |  | |
| Truss rod and shielded electronics
cover | Neck
Plate and mounting screws with truss rod allen wrench | |
 |  | |
| 15:1 High Quality sealed tuners | String Pack, cord and decal | |
 |
Complete instructions provided |
 |
| Directions for finishing | Directions for assembly | |
| Things you
will need | Things
you will need | |
| Small
saw for shaping the headstock, sandpaper, paint and buffing supplies | Philips Screw driver, 7/16"
wrench, lighter |
